On 8/20/2012 3:14 AM, Cal Dershowitz wrote:
Hello newsgroup,

You know how I always seem unqualified for my next task? For some, it's
the Peter principle. For me, it's the Paul principle where I have to
figure it out 2 steps ahead of everyone else.

I have a plaster project in fifty percent humidity, 8000 feet. Things
are pretty wet up there by Fenton Lake, NM.

I have a plaster job to complete, but I don't know for sure many things
about it.

Q1) Does one "wet-cure" or "dry-cure" plaster? With stucco around
here, we wet-cure it for weeks under this sun. This is interior and
will be able to be wett-ed down well before application.

What are the best materials? I was thinking stucco-lite as a base coat,
but I haven't found a finish coat for that yet.

Will post pics when I get to it.


Cal, I use USG Structolite often. I use the same product for scratch,
brown, and finish. On small work you may be able to go from scratch to
finish, though the dry/cure time is much faster than conventional
materials. On interior work I've not worried about curing beyond pre
wetting the substrate. A light mist/spray of each layer should keep
the bond and shrinkage to a minimum. I have been able to achieve the
desired finish with the product. Check with your supplier, but it is
compatible with Diamond or Imperial finish if that works better for you.
The convenience of one product, water only, and good performance has
worked well for me. I do wish they still made the earlier pinkish
product with the hair, but I've not had a problem with this newer white
product.

--


___________________________________

Keep the whole world singing . . .
Dan G
remove the seven