On Thu, 16 Aug 2012 17:25:37 +1000, John G
wrote:

John B. formulated on Thursday :
On Wed, 15 Aug 2012 19:38:19 -0400, wrote:

On Tue, 14 Aug 2012 20:27:20 -0700, "Steve B"
wrote:


"Richard" wrote



If it's more than a single axle, remember, they are to be wired in
parallel, not series.

A battery and controller sitting by the wheel might help.

Wire it up and squeeze the tit.
See it the brake moves.

Check them all, If they all work, back track through the wiring to the
connector.

DON'T use the trailer frame for ground!

And a circuit tester with a light works better than volt meter.

Thanks for the tips. I woulda got the ground thing wrong.

Steve

Commercial trailers have been using the frame for ground for decades -
and it works if it is done PROPERLY. Harder to screw up a fround WIRE
than a frame, but also easier to damage the WIRE. Six of one, half
dozen of the other, in my books. I'll stick with a "chassis ground" -
same as used on the tow vehicle, and same as has been used for
decades.

Don't most automobiles uses a "frame ground" :-)
Cheers,
John B.

No.

Correct. And I recreated all sorts of wiring looms for autos for which
no harness was available back when I worked at the body shop.

Only the Brits, using "Lucas, Prince of Darkness" technology, use body
and frame grounds. Ask any Brit car owner how he likes it.
But be prepared to run. Some are _really_ fired up about it.

--
All of us want to do well. But if we do not do
good, too, then doing well will never be enough.
-- Anna Quindlen