best way:
On 8/14/2012 8:22 PM, sal wrote:
Hi I have a scenario to run bye you guys I have to cut 1/2' plywood panels
with 45 degree edges to make mitered joints .Is it better to cut plywood
square and then run it though the router table that has a 45 degree bit?
Sal
When working with plywood you typically will get a better cut with a saw
blade than a router bit in this situation.
That said if your panels are relative large and are not perfectly flat
your 45 degree cuts will not be straight or consistent.
Experiment on scraps!
|