On 14 Aug 2012 04:20:04 GMT, the renowned Winston
wrote:
On Mon, 13 Aug 2012 14:36:32 -0400, Tom Gardner wrote:
My "UNIQ" 2-axis DRO display has failed. The vendor says the power
supply is bad and can't get a replacement. They have offered a direct
replacement "UNIQ" for $295 or a "JENIX" display for $200.
I have asked them to return the unit. Does anyone know anything about
these? Would the PS be fairly easy to repair? I'll know more when I
get it back and apart.
http://www.penntoolco.com/catalog/pr...ategoryID=6219
Power: DC 5V (15%) 80 MA.
Does that use a wall wart, Tom?
'Should be very easy to replace.
--Winston
80mA (400mW) doesn't sound like nearly enough. Maybe that's the power
_output_ for the scales.
The "Sino" lathe DRO I have contains a small more-or-less open-frame
5VDC switching supply, just 5V out. about 140 x 60 x 40mm. I would
expect yours is quite similar. Similar 25VA units are around $20 qty
1.
(RS-232 for the last decade or two generally used +/-V generated from
5V or 3V using a MAX232 or similar chip).
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers:
http://www.speff.com