Thread
:
Hot melt glue gun failure
View Single Post
#
5
Posted to sci.electronics.repair
N_Cook
external usenet poster
Posts: 5,247
Hot melt glue gun failure
hr(bob)
wrote in message
...
On Aug 5, 8:18 am, "N_Cook" wrote:
N_Cook wrote in message
...
What goes wrong with such guns?
Probably overheated and then the resistor block inside goes skew and
blocks
the melt flow path. While molten but switched off , a rod through the
nozzle
hits something solid , probably ceramic of a wire-wound. When powered,
pushing a hot-melt rod in the entry hole, little exudes from the nozzle,
requiring greater force than usual, outer housing seems to have expanded
a
bit as well.
When I get a new one , this one will have a PM, but in the meantime , if
anyone has been inside one before.
Fixing a Jubilee clip, while hot, around the nose seems to have fixed it,
presumably the heater block realigned itself, but time for a new one
anyway.
What is a Jubilee Cap????
+++++
my translator
http://www.divdev.fsnet.co.uk/tool_terms.htm
if anyone has any additions then please add them to this thread
Reply With Quote
N_Cook
View Public Profile
Find all posts by N_Cook