Hot melt glue gun failure
On Aug 5, 8:18*am, "N_Cook" wrote:
N_Cook wrote in message
...
What goes wrong with such guns?
Probably overheated and then the resistor block inside goes skew and
blocks
the melt flow path. While molten but switched off , a rod through the
nozzle
hits something solid , probably ceramic of a wire-wound. When powered,
pushing a hot-melt rod in the entry hole, little exudes from the nozzle,
requiring greater force than usual, outer housing seems to have expanded a
bit as well.
When I get a new one , this one will have a PM, but in the meantime , if
anyone has been inside one before.
Fixing a Jubilee clip, while hot, around the nose seems to have fixed it,
presumably the heater block realigned itself, but time for a new one anyway.
What is a Jubilee Cap????
|