On 7/24/2012 4:50 AM, Ed Pawlowski wrote:
On Mon, 23 Jul 2012 21:41:02 -0500, wrote:

On 7/23/2012 9:37 PM, Roanin wrote:
What is the difference between a flush trim bit and a laminate trimmer bit
that you would use for trimming a laminate countertop sheet edge.
...

Length/diameter and often trimmers use angle not just straight flush.

Flush trim come in multitudes of sizes and diameters; you only need
short and preferably smaller diameter (chip out is less) for laminate.


To add on some clarification . . . there are small hand held laminate
trimmers (small router type tool) that use those bits as opposed to a
much larger typical wood working router that uses the "flush trim"
bits

But they're usable in any router of the proper collet size...either way.
The laminate trimmer as a specialty tool is somewhat of a newcomer on
the scene.

--