On Wed, 18 Jul 2012 19:56:05 +1000, "Chas" wrote:
Carefully drill the solder out with a PCB drill slightly smaller than the
hole.
Bad idea. That usually rips out the plating in the hole. The drill
collects a mix of solder and copper around the outside, which galls
together with the solder plating inside the hole, and eventually rips
out the plating. Even if you can find a workable drill, keeping the
drill exactly perpendicular to the PCB is quite difficult.
--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060
http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558