Protecting pub type table legs from rot
On 19/07/2012 5:55 a.m., Harry Bloomfield wrote:
Harry Bloomfield presented the following explanation :
My best idea at the moment is to drill a hole into each leg and fit a
steel bolt, so each leg is raised off the ground by the heads of the
bolts. The holes simply being a tight push fit for the thread of the
bolt. Has anyone got any alternative suggestions please?
Which is the idea I have finally settled upon and thanks for the
replies....
I used some very large galv bolts I happened to already have, measuring
2" x 5/8" OD across the threaded part, rounding the heads in the lathe
so they wouldn't dig in when trying to move the bench. I then bored the
feet to accept the bolts with a tight fit. The timber of the feet now
sit 1/2" clear of the concrete and the wet surface.
Sounds like a good plan to me, simple and effective.
|