On Tue, 17 Jul 2012 15:37:31 -0700, mike wrote:
You left out the MOST IMPORTANT first step!!!
Wear eye protection!!!
Compressed air and molten solder is a recipe for blindness!!
Thanks. Y'er right. Goggles or a face mask are a must.
Back in the days when it was worth the effort, I used to remove
components from a PCB by clamping one end of the board in a bench vise
and heating the solder side with a propane torch. When the solder was
good and hot, I would pull the board back and let go. The components
and the solder would go flying in the opposite direction into a
cardboard box. I always wore a face mask, but still managed to burn
myself in obscure places.
--
Jeff Liebermann
150 Felker St #D http://www.LearnByDestroying.com
Santa Cruz CA 95060
http://802.11junk.com
Skype: JeffLiebermann AE6KS 831-336-2558