On Jul 11, 2:13*pm, DerbyDad03 wrote:
On Jul 11, 2:04*pm, "hr(bob) " wrote:
On Jul 10, 3:11*pm, "TomR" wrote:

Also, since you said you have to cut off about an inch, I wonder if it would
make any sense for you to try whatever method you are going to use first by
only making the first cut off be about 1/4 inch or so. *That way, you could
see how the material cuts before making the final cut.

The OP didn't say if it was to be a 1/2 inch on each end or 1" all off
one end. *Depends on how it is fastened to the rest of the tub.

Also depends on whether it has a design on it or not. It might need to
be cut from both ends for balance.

Maybe it doesn't have to be balanced on the center. It could be a
cantilevered whirlpool tub.

R