Mike Marlow wrote:
Larry Jaques wrote:


2) Fab up a solid rod which can fit in the emt so you can clamp it
tightly while bending it, preventing it from twisting while you make
the compound angle bends. (Weld a doglegged rod to a thick flat plate
with a hole in it so you can bolt it down, holding that bottom end
while bending, KWIM,V?)


Holy Cow Larry - that's way over the top. Much easier to just use the
bender...


It got dark on me too early today. I'll give it "the ol' college try"
tomorrow. If I should fail my bending test, I'll go the FMC route.