Thread: Sharkbites
View Single Post
  #6   Report Post  
Posted to alt.home.repair
DerbyDad03 DerbyDad03 is offline
external usenet poster
 
Posts: 14,845
Default Sharkbites

On Jul 9, 10:05*am, "Steve B" wrote:
"DerbyDad03" wrote in message

...
On Jul 8, 11:22 am, "Steve B" wrote:

Got to my cabin, and had two burst pipes. Had lent it to some friends, and
obviously they had not followed procedure on shutting down the water. I
used Shark Bites to repair one place under the cabin, and one place in a
2x4
stud wall. What a joy to use for repairs.


Steve


Which fittings did you use?

I've used straight connectors, tees and caps.

I haven't tried any of the slip fittings yet. Did you?

I was watching a football game one time. When a commercial came on I
went downstairs, turned off the main, cut the pipe to the backyard
spigot, capped it with a SharkBite cap and turned the water back on,
all before the commercial was over.

Other than the cost, they are great. For quick fixes and hard to sweat
locations, they can't be beat.

****

I thought they all were slip fittings. *Anyway, I used two straight slips on
one piece, and two on another. *The longest time is for cutting out the old
section, and cutting a new piece of replacement pipe. *They were in
inaccessible places, but I use them everywhere on the cabin so I do not have
to sweat anything. *The woods are very dry, and there is serious fire
danger.

Steve


Actually, they are all referred to as Push-Fit fittings, not slip
fittings.

Only the ones at the bottom of this page are considered Slip Fittings/
Slip Couplings by Cash Acme:

http://www.cashacme.com/prod_sharkbite_pushfit.php

The Slip Fittings are their equivalent of a repair coupling in that
you can slide (slip) the long side of the fitting along the pipe.

Those are the ones I've never tried, although had I known they
existed, I could have used one of the slip tees on a job I did. I was
lucky to have just enough play to get a regular tee where I needed it
but a slip tee would have been much easier.

I've sweated a complex multi-fitting section on the bench and then
used a Sharkbite up in the joist bay to connect it to the existing
pipe. Saved a bunch of money and work that way, plus no sweating in a
confined space.