In article ,
"Jim Wilkins" wrote:

"Ned Simmons" wrote in message
...
On Sun, 01 Jul 2012 21:09:50 -0400, Joseph Gwinn
...
Any reason you can't use a regular endmill and tip the part 35
degrees
to cut the angle?
Ned Simmons

Or a standard, more acute angle like 60 degrees and tilt the blank 5
degrees?
http://www.endmill.com/software/Meli...nd%20Mills.pdf

One can, but there is no speed advantage over a straight endmill - the
setup time is the same.


MSC doesn't like my Cookies setting.

It does that to me also. If I just try again, it usually becomes happy.


Joe Gwinn