On Sat, 23 Jun 2012 12:06:40 -0700 (PDT), MJ
wrote:

Ok, I'm amount to tackle a project where I need to
cut some plywood to "dead nuts'. I can rip easily enough
with my TS, but cross cutting will be a challenge and not
possible with my TS (not enough real estate on the saw for the cut).

I was thinking of cross cutting with a circ saw to a length
slightly larger than what I needed, then come back and
use a router with a compression bit to get it "dead on".

Any other good suggestions?

How much time and money do you want to invest?
build in-feed and -out-feed tables for the table saw.

Depending on the width of the cross cut, a sled does a nice job.