"rangerssuck" wrote
-OK, I'll take a whack at this: How about you hold the pin in a collet
-in a collet block such as this:
http://compare.ebay.com/like/3505536...pes&va r=sbar
Accurate but slow.
I've clamped a row of small pins upright in the milling vise with a
block of wood or hardboard on the moveable jaw side that compresses to
grab -all- the pins. They can be pre-aligned against the inside corner
of a square and held in place with tape.
If their lengths vary and you want the tops to line up, clamp them in
a small insert vise upside-down, with thin parallels under the vise so
the pins extend beyond the jaws. The pins can be stuck upright onto
double-sided tape to make handling them easier.
jsw