Followup on the Darex E-90
"Lloyd E. Sponenburgh" lloydspinsidemindspring.com wrote in message
. 3.70...
"Jim Wilkins" fired this volley in
news:jojkk6$pod$1
@dont-email.me:
0.5" times the sine of 1 degree is about 0.008"
Thanks, Jim. The trig I can do, but that goes in the archive,
because it
saves me a LOT of math. G
Lloyd
When I set up my surface grinder to sharpen lengthwise flutes I adjust
the spring finger (hacksaw blade end) to a protractor beam or angle
block that crosses through the tool's center axis at 5 degrees from
vertical.
jsw
|