On Thu, 9 Feb 2012 19:57:15 -0800, DaveC wrote:

A 1/2(?) horsepower 2-brush DC motor was having bearing issues so I
disassembled it and replaced the ball bearings, turned down the commutator on
a lathe, and installed new original equipment brushes. A good clean-up was
done as there was much grease and carbon dust inside.

Now when I apple power it just growls. If I turn it by hand with power
applied it will turn 1 or 2 revolutions then stop. Before disassembly the
motor ran as expected.

The field and armature are separately terminated at the outside of the motor
and wired to a motor speed control PCB.

The commutator segments are well-separated. I put an ohm meter on the brush
terminals and turned the motor slowly. I see 10 ohms across the armature with
each commutator position (each brush contacts 3 segments). The field measures
1000 ohms. I thought that a bit high, so I found where the 2 separate field
windings are connected (in series) and measured each winding separately: each
is approximately 500 ohms.

There is no mechanical reason the motor should not spin at speed. By hand, it
turns freely and there is no interference between the armature and field
laminations(?).

The motor is rated at 180 volts DC, 1.5 amps. There are 2 separate field
windings (wired in series) and the commutator has 36 segments.

I've had this motor apart several times but still can't find a reason it's
not operating like it should.

Any suggestions would be greatly appreciated (and the sooner the better ;-)
).

Thanks,
Dave

Any chance that the angle between the brushes and the field got
changed on reassembly?



--

John Larkin, President Highland Technology Inc
www.highlandtechnology.com jlarkin at highlandtechnology dot com

Precision electronic instrumentation
Picosecond-resolution Digital Delay and Pulse generators
Custom timing and laser controllers
Photonics and fiberoptic TTL data links
VME analog, thermocouple, LVDT, synchro, tachometer
Multichannel arbitrary waveform generators