View Single Post
  #14   Report Post  
Posted to sci.electronics.repair,rec.radio.amateur.antenna,sci.electronics.design
Ralph Mowery Ralph Mowery is offline
external usenet poster
 
Posts: 4,228
Default Increasing Cable TV signal strength


"amdx" wrote in message
...
Hi All,
I'm on a boat, about 170ft from the utility post.
Recently our cable company switched to the wonderful world of
Digital TV. I got the new digital converter and had no picture.
I took the box back and got a second box, still no picture. So now I
suspect a weak signal and confirm that it is the cable length. The cable
company came out and gave me a better cable than I had installed. At this
point I have a picture but it is intermittent. The signal at the utility
post has 3 outputs and had a four way splitter, I suggested the cable guy
put in two 2 way splitters and give me the stronger (first) tap.
That got my signal to work almost all the time. I'd like to get the
signal to work 100% of the time.
I don't has access to electricity at the utility post, so an amp is out.
Although I could try an amp at the cable box end. Is that reasonable?
I would run two cables if there was a way to make it increase signal
strength.
Getting anymore from the cable company is not an option.
Any ideas to get a better signal?
Mikek


At only 170 feet, that should not be a problem. My cable runs down a
utility post, then over 200 feet to my house. It goes to a 2 way spitter
and then about 30 feet to a cable modem. The other end goes to anotehr two
way splitter, one side to a regular TV and the other to a digital box.

No problem with the TV signal at my house, and the internet is around 7 MB
or however they measuer it. That is by my test on the internet and what
they say I am paying for in the speed./


Sounds like they need to send more signal from the main cable to the taps to
your line.