How to unbraze silver buttons from copper switchgear contacts
On 2012-01-23, Steve W. wrote:
Ignoramus6092 wrote:
On 2012-01-22, Jon Elson wrote:
Ignoramus6092 wrote:
I have a couple of medium voltage switchgear contacts, with seemingly
silver buttons brazed to them. I have a little heat treating oven. How
can I use it to unbraze the buttons, to what temperature should I set
it?
Man! Without knowing a bunch about the silver alloy and the brazing
alloy, it is pretty hard to know what would be the magic temperature.
If you had a barrel of them, you could do a couple tests to find
the temp.
I only have two, I would say I can make 1-1.5 ounce of silver from the
contacts.
i
So it costs you 10 bucks in electric current and an hour or so of time
(mine runs $35.00/hr for odd work) To make about 5 bucks?
How about a simpler solution? Take the contacts, clamp them so the
buttons are hanging down. Then hit the back side of the contacts with a
MAPP torch and let the contacts fall off. Might take 5 minutes to do.
I will do just that, perhaps with O/A instead.
i
|