On Jan 10, 11:11*am, bob haller wrote:
On Jan 10, 11:40*am, Bill Ventura wrote:





I'm changing out my kitchen ovens and the new one
needs an additional 3/8 to 1/2" of side clearance. *It is
a sheetrocked wall, 1/2". * *Because it will be hidden
doesn't matter about looks. *The oven is rated to be
installed in wood cabinets with essentially zero
clearance. *Some options that come to mind:

1 - Remove the drywall and trim the studs down by 1/2"
over the full height of the wall using a router? *Other ideas?
Then re-drywall. The wall is non-load bearing.

2 - Just leave the one section of hidden wall where the
ovens are without drywall. *It's just a short wall, not open
to anywhere above or below and will never be seen.

3 - Same as two but use sheetmetal to cover the studs.

4 - Other ideas? *Is there some other product that
is thin and can be used instead of sheetrock for
something like this?

Thanks for any input!

replace 1/2 inch drywall with 5/8ths- Hide quoted text -

- Show quoted text -

He wants thinner, not thicker