On Tue, 10 Jan 2012 10:06:05 -0800, Oren wrote:

On Tue, 10 Jan 2012 08:40:57 -0800 (PST), Bill Ventura
wrote:

I'm changing out my kitchen ovens and the new one
needs an additional 3/8 to 1/2" of side clearance. It is
a sheetrocked wall, 1/2". Because it will be hidden
doesn't matter about looks. The oven is rated to be
installed in wood cabinets with essentially zero
clearance. Some options that come to mind:

1 - Remove the drywall and trim the studs down by 1/2"
over the full height of the wall using a router? Other ideas?
Then re-drywall. The wall is non-load bearing.

2 - Just leave the one section of hidden wall where the
ovens are without drywall. It's just a short wall, not open
to anywhere above or below and will never be seen.

3 - Same as two but use sheetmetal to cover the studs.

4 - Other ideas? Is there some other product that
is thin and can be used instead of sheetrock for
something like this?

Thanks for any input!

1/4-inch thick drywall (if you can find it locally)
Tempered hardboard or 1/4" plywood come to mind.