I would like to know the typical diameter of the punch/anvil where it
goes into the machine. Stated as 3/8" but not whether the hole is made
a bit oversize, the shaft a bit under, or both.
Is there some standard? Metric guide pins seem to be symmetric- holes
5-14 microns oversize and pins 5-14 microns undersize.
(I'm making a punch and anvil and fitting it to a non-PEMserter press,
but it would be nice to make it so it could accept the standard PEM
tooling- it's not insanely expensive and is no doubt made properly)
P.S. I did ask PEM's support folks, but nobody there could help- maybe
they're all off on vacation.
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers:
http://www.speff.com