Nothing working , neither motor, 1Meg across mains "on or off". No obvious
water ingress, nasty smells, or burning. 24 segment armature, .2mm wire , 25
to 27 ohm across brushes for 1 rev.
Beater motor opened up, bowl motor not seen. A thin multistrand wire with
yellow sleeving , loose inside with no obvious tag remnants to the motor.
The stator has yellow high temp tape around it and picking off part of the
last turn there is a broken wire with a lot of copper carbonate corrossion.
But this wire is .15mm which seems small for a presumed 380/2 W motor , 380W
m/c total. Some sort of sense wire ? and without it the , unseen, presumed
triac control inside the handle is disabled. I find it difficult to believe
..15mm wire would be actively in a mains motor stator even if it is for the
slowest setting. 8 exposed magnet wire ends around this stator of .4, .2 and
..15 mm diameters if the broken one is included. Even if repaired how to
avoid more water/condensation damage on such fine wire ?