On Sat, 10 Dec 2011 20:36:11 -0600, "Lloyd E. Sponenburgh"
lloydspinsidemindspring.com wrote:

Miller syncrowave 250 in working condition. mounted on 4 swivel casters.
(no mention of Tig-mate, etc) along with stick & ground leads, air cooled
tig torch & argon bottle.

Lincoln Pro Cut 60 plasma cutter, not working

Quincy 390-20, 3ph, 15hp air compressor, working, cleaned and painted.
Confirmed... this is a low-pressure compressor. All those of that series
were.

40' 10" x 25lb channel iron, clean,

All delivered to my shop from 60 miles away for:

$4,500.00

-------------

I'm figuring $1000 for the welder, $500 for the unknown condition cutter,
$1000 for the compressor, and $200 for the steel.

Add $200 delivery for 3500lb. ---- $2900???

Whatcha think? (Ig?)

LLoyd

You are going to have to remove the cutter from the list...yu dont know
how much it will cost to repair..or even if its repairable

Based on pricing around here..it will cost more than 500 to repair

Figure from there.

Gunner

One could not be a successful Leftwinger without realizing that,
in contrast to the popular conception supported by newspapers
and mothers of Leftwingers, a goodly number of Leftwingers are
not only narrow-minded and dull, but also just stupid.
Gunner Asch