Skil grinder question
On Fri, 2 Dec 2011 09:57:08 -0800
"Steve B" wrote:
snip
Is it common for these to stop so quickly, or are the bearings needing lube,
or getting tight from gunge?
I think it depends a lot on what kind of wheels you have mounted and
size/mass of the armature. My 3/4 hp with two 8 x 1 inch wheels spins up
and down slow. Another maybe 1/2 hp motor with just an 8 inch wire wheel
spins up and down much quicker.
If you can spin it by hand freely with no noticeable noises I wouldn't
get too concerned.
--
Leon Fisk
Grand Rapids MI/Zone 5b
Remove no.spam for email
|