"Tim Wescott" wrote in message
...

I'm building model airplanes. Nearly everyone bends up their landing
gear out of music wire (0.9% carbon, low alloy, hard drawn wire), and
either holds the wheels on with these really ugly collars, or they epoxy
on washers.

The washers won't come off when you want them to, and do come off when
you don't. I'm thinking up a few schemes to do a nicer job, some of
which would go a lot nicer if the steel were drawn a lot more than it
is. I don't want to go using my nice 5-44 die on hard steel, nor do I
want to try drilling .050" holes.

So: how to anneal, and how to just draw the temper a bit more? For
annealing I expect that I can just clamp the thing in my vise (both to
hold and to limit heat travel), get the end as hot as it'll get with a
propane torch, and let it cool. To just draw it, should I do something
like filing a spot shiny, then heating it to blue or purple, then letting
it cool? Or is there a better way to do this by eyeball methods?

Comments appreciated. I know how to make it work with rocks and sticks,
I'd just like pointers on using hammers and screwdrivers for the job...

--
www.wescottdesign.com

================================================== ==============

Anneal: Get it dull red, stick it in some ashes or powdered lime. Ashes will
be better with music wire. Lime might actually re-quench it, if the wire is
thin.

Draw: For music wire, drawing it locally, I heat a piece of steel rod to
red, lay it against the music wire; draw to the color you want; and
water-quench *fast*. If you're heating just the end and if you have an
electric stove top, you can just lay it on a burner coil.

Here's a color chart:

http://www.anvilfire.com/FAQ-article...0anvilfire.com

The colors are really not that clear. They're more like this:

http://en.wikipedia.org/wiki/File:Te...s_in_steel.jpg

1095 is close to music wire.

Music wire should be shiny enough to see the colors without filing. If you
have to clean it, I'd use some 300/400 grit wet/dry sandpaper rather than a
file.

To safely thread it with a die, I'd go for at least dark blue.

Good luck.

(BTW, this is not the best way to anneal or draw plain carbon steel in
thicker sections. But the better methods aren't going to be very practical
with wire.)

--
Ed Huntress