On Mon, 07 Nov 2011 03:57:32 -0600, Karl Townsend
wrote:

On Sun, 06 Nov 2011 18:22:37 -0800, Gunner Asch
wrote:

On Sun, 06 Nov 2011 17:18:16 -0600, Karl Townsend
wrote:

I'm looking for endmills that are sort of shaped like a woodruff key
cutter. That is an endmill with a smaller shank than the cutting
edges. One with something like a 1/2 inch shank and a 3/4" diameter
cutter. is there a name for for this type of endmill? Know of a
source?

I need to cut shallow slots in a side wall of a big slot, if that
makes sense.

Karl

What "thickness" of cut do you need?

Gunner

One could not be a successful Leftwinger without realizing that,
in contrast to the popular conception supported by newspapers
and mothers of Leftwingers, a goodly number of Leftwingers are
not only narrow-minded and dull, but also just stupid.
Gunner Asch

A fair bit of metal to remove: the slot is 0.100 deep, .800 wide and
2.0" long on the side wall of a big slot in 4140. Two per part, 25 or
more parts. I know a woodruff would never hold up. I see they make
indexable T slot cutters, I'm watching eBay now.

Karl

The reason I asked, was Ive got a shoebox filled with T slot cutters.
Probably 150 or more of them. But nothing .800. The biggest Ive got is
..500


One could not be a successful Leftwinger without realizing that,
in contrast to the popular conception supported by newspapers
and mothers of Leftwingers, a goodly number of Leftwingers are
not only narrow-minded and dull, but also just stupid.
Gunner Asch