name this cutter
On Sun, 06 Nov 2011 17:18:16 -0600, Karl Townsend
wrote:
I'm looking for endmills that are sort of shaped like a woodruff key
cutter. That is an endmill with a smaller shank than the cutting
edges. One with something like a 1/2 inch shank and a 3/4" diameter
cutter. is there a name for for this type of endmill? Know of a
source?
I need to cut shallow slots in a side wall of a big slot, if that
makes sense.
Karl
What "thickness" of cut do you need?
Gunner
One could not be a successful Leftwinger without realizing that,
in contrast to the popular conception supported by newspapers
and mothers of Leftwingers, a goodly number of Leftwingers are
not only narrow-minded and dull, but also just stupid.
Gunner Asch
|