View Single Post
  #27   Report Post  
Al Reid
 
Posts: n/a
Default Amperage for 5HP table saw?

Hey DonkeyHody, don't get your drawers in a knot!! I thought we were having a discussion. As anyone that has dealt with the NEC or
other NFPA publications, interpretation is everything. And I have found that there is no universal interpretation of all aspects of
the code.

I was merely expressing my doubts as to the wisdom of violating the 30A on a #10 wire rule in section 310. Most inspectors get hung
up un that one and usually don't budge. Perhaps, my designs are too conservative, however, I have never had one rejected by a PE
review before installation or by an inspector during/after installation.

Also, I started my comment by stating that I did not have my code book in front of me.

--
Al Reid

"It ain't what you don't know that gets you into trouble. It's what you know
for sure that just ain't so." --- Mark Twain

"DonkeyHody" wrote in message m...
Well, now you caught me without my code book but that seems to imply that it is a dedicated, hardwired motor, being supplied by

a
motor controller that incorporates both instantaneous (like an MCP) and overload protection AND that it pertains to the wiring
between the motor controller and the motor.

I could be wrong, but I doubt you could convince a residential electrical inspector to pass an installation with #10 wire being
protected by a 40A breaker.


Al,
That section is specifically NOT about the factory installed wire
between the factory installed motor controller and the motor. I went
to the trouble to look up the reference for you and even took the time
to quote chaper and verse. I'm not going to type the whole chapter
for you. If you want to argue context, at least go to the trouble to
read the chapter so you'll know what your're talking about.

Now I remember why I mostly just lurk here.


DonkeyHody
We should be careful to get out of an experience only the wisdom that
is in it - and stop there; lest we be like the cat that sits down on a
hot stove-lid. She will never sit down on a hot stove-lid again---and
that is well; but also she will never sit down on a cold one anymore.
Mark Twain