For the 2 Cole Drills that I have, the ratchet gizzy is just threaded..
right-hand internal thread (for clockwise turning of a drill during
cutting).

There are threads above the ratchet and handle hole on these versions, which
are the type that the drill adapter was available for.

While holding the spindle stationary, using something similar to a
channel-lock/slip-joint type plier to grip the ratchet (over a rag or
something to prevent metal removal), it will screw off turned CCW.

If your design is different, maybe someone else has experience with it. I've
seen other designs, but they weren't marked with the Cole name.

--
WB
..........


"Jon Anderson" wrote in message
news
On 10/31/2011 6:32 PM, Wild_Bill wrote:

BTW, a drill motor can be added to a Cole by taking the handle and
ratchet wheel off, and using an adapter threaded onto the shaft (Cole
used to supply such an adapter).

How exactly does this ratchet come off? Can't see a setscrew nor pin on
the ratchet. It appears to be pressed onto a reduced section of the
spindle. Maybe a 2 jaw gear puller?


Jon