Mixing 4 audio channels to 3?
On Wed, 26 Oct 2011 11:52:49 -0700, DaveC wrote:
That depends entirely on the input impedance of the subwoofer. You
could try a 100k pot and connect it as a normal volume control - one
end to the incoming signal, the other end to ground and the slider to
the subwoofer.
d
The data sheet says that the 2 single-ended inputs (R & L) are 50K impedance.
The bridge-tied load ("BTL") input -- used for the sub -- is 25K impedance.
Does this suggest any change to your recommendation of a 100K pot tied to
ground?
Thanks.
No, that would be about right.
d
|