View Single Post
  #14   Report Post  
Posted to alt.binaries.pictures.woodworking
Leon[_7_] Leon[_7_] is offline
external usenet poster
 
Posts: 12,155
Default The Murphy bed project

On 6/3/2011 10:30 PM, willshak wrote:
Leon wrote the following:
Well this large project has finally come to an end and the money is in
my pocket.

Oddly the bed was easier to bring into the customers designated room
than the two side towers. We had to lean the towers away from the door
opening to have enough room to slide them under the top of the door
jam. Using a towel under the tower we pushed the tower top away from
the door opening and used the towel to pull the bottom into the door
opening. Because there was a hall lamp directly above we had to lean,
pull, lean, pull and so on until we cleard the jam and lamp. WHEW!
There was not enough room to lean the tops of the towers towards the
door opening. I don't want to be around if they decide to remove them
from that room.

Oak and Arkansas Black Walnut for the pulls. Drawers are KV G-slide
full extension side mount soft close. 4 adjustable shelve in each.
Towers are apparently 4 incher taller than I thought.


Great job, and your name is not even Murphy


Thank you Bill