Exploring rotary encoder problems
Mark Zacharias wrote in message
.com...
"N_Cook" wrote in message
...
Deeper than just saying clear out the grease. 2 in 2 days, first input
selector of an amp , not explored in depth, second vol control of a
music
centre.
First had radial contacts that were slightly staggered and the fixed
contacts were in line , second was exact radial contacts and staggered
fixed
contacts. On the second I took some R measurements before and after.
There are 3 contacts, one common and the other 2 staggered to pick up CW
or
CCW rotation. Just measuring between the 2 sense contacts as at some
point
they are cross connected, measured 2.5R each of the posistions but very
tiny
position to get this reading. Ladled out and then dissolved the grease,
reassembled and took readings again . Now 1.5R each bridging posistion
and
a lot easier to find that posistion, ie more latitude. I imagine from
the
consistency of the R readings that something to do with deforming or
block
under one of the contacts reducing the contact to a very small area and
then
only marginal connection posistion bridging the 2 contacts. I assumed
the
electronic sensing was one line before the other but perhaps duration of
both contacts on simulataneously, or not, is also something to do with
normal sensing
Clean the moving contacts and stationary contact area as you would relay
and
switch contacts. Better to replace the control, but this will fix it.
Mark Z.
I've never seen a relay with grease it it. Rotary encoders or the BCD type
ones, it is the grease thats the problem but exactly why it is a problem is
still not fathomed. I assume a hardening or accretion process that
eventually wedges under a wiper. Why do they not use "dry lubricant" perhaps
locksmith's graphite as long as in a minute quantity.
|