In article ,
micky wrote:
Is there a decent technique to drill holes in metal at an angle?

My "new" car has more empty space in the engine compartment, but it
has almost no "wall space". There are a couple spots big enough to
mount things, but nowhere near big enough to get an electric drill in
to drill the mounting holes, nor enough for one of those right angle
or flexible cable attachments. Not enough for a center punch and
hammer, although maybe enough for a hammerless center-punch (what do
you call those?)

But I could get a drill bit in at maybe a 45 degrees angle.

I thought maybe I could put my finger on the bit and hold it in place
while I dirilled, but maybe there's a better way.

9 millimeter full metal jacket? Seriously, could you use a right-angle drill
with a short bit like these?

http://www.amazon.com/Milescraft-232...ref=pd_cp_hi_0




--
There are no stupid questions, but there are lots of stupid answers.

Larry Wasserman - Baltimore Maryland - lwasserm(a)sdf. lonestar. org