On 8/16/2011 7:21 PM, Jon Kirwan wrote:
On Tue, 16 Aug 2011 19:11:18 -0700 (PDT), "larry moe 'n
wrote:

When I come across a burnt resistor, I usually replace it with one
rated for twice the wattage as the original, but I was told it's
sometimes bad to do that. Why? I'm not referring to fuse resistors
but ordinary carbon composition resistors.

Hmm. Not obvious why there would be a worry. The
differences amount to the following:

1) Longer body, and
2) Larger body diameter, and
3) More weight, and
3) Lower temperature at given power dissipation.

Other than the thought that it does have a fuse function,
which you dispute above, there can be:

A) The longer body or larger body diameter causes the wiring
to be too close to nearby parts, mechanically stresses
something, or blocks some hole that needs to be clear, or
B) The greater weight causes some problem (such as if it
were at the end of a propeller, for example), or
C) The lower temperature affects something else that depends
on the earlier higher temperature.

In short, I can't think of a problem that would not be pretty
obvious when you were replacing it. But then my imagination
ain't what it used to be, either.

Jon


If the original resistor burnt, something is wrong and needs fixed.

Replacing the resistor with a bigger one is not in any manner a solution.

--
Many thanks,

Don Lancaster voice phone: (928)428-4073
Synergetics 3860 West First Street Box 809 Thatcher, AZ 85552
rss: http://www.tinaja.com/whtnu.xml email:

Please visit my GURU's LAIR web site at http://www.tinaja.com