two stroke chainsaw conked and won;t restart
"Howard Neil" wrote in message
o.uk...
On 16/08/2011 10:29, Jim K wrote:
Fave chainsaw played up t'other day - had been using for an hour or two -
all as normal - then starting dying when should have been idling - i.e.
make
a cut release throttle trigger, and revs drop down and .....conk.
Would restart -on full throttle - and OK at revs but conked again when
returning to idle.
Next day the fecka won;t start at all.
Had plug out, bit sooty but cleaned up OK, magneto creating a spark -
felt
through fingers from plug lead, quite hard to see spark on plug tho??
Fuel OK (other backup saw running well on it), after trying to start
(again)
plug/cylinder is wet so presume fuel getting there.....
Has a decompression system to start and is hard to pull without using it
so
assuming compression OK.....
Will get a new plug - anything else?
Recently it was stored on it's side overnight due to persistent chain oil
leak - could this be related?
TIA
Jim K
Air filter blocked?
well it ran at high revs until it failed so assuming air and fuel was/is not
an issue... plus the air "filter" is only a fine gauze screen that looked in
a reasonable state (has been worse w'out this issue)
Cheers
Jim K
|