two stroke chainsaw conked and won;t restart
Jim K wrote:
Fave chainsaw played up t'other day - had been using for an hour or two -
all as normal - then starting dying when should have been idling - i.e. make
a cut release throttle trigger, and revs drop down and .....conk.
Would restart -on full throttle - and OK at revs but conked again when
returning to idle.
Next day the fecka won;t start at all.
Had plug out, bit sooty but cleaned up OK, magneto creating a spark - felt
through fingers from plug lead, quite hard to see spark on plug tho??
Fuel OK (other backup saw running well on it), after trying to start (again)
plug/cylinder is wet so presume fuel getting there.....
Has a decompression system to start and is hard to pull without using it so
assuming compression OK.....
Will get a new plug - anything else?
Recently it was stored on it's side overnight due to persistent chain oil
leak - could this be related?
TIA
Jim K
sounds like a blocked fuel supply somewhere.
Check the clunk is not clogged, and clean the carburettor jets.
Not sure how these carbs work, but if that was on a 60's car, I'd
diagnose 'blocked idle jet' instantly.
|