Rob-J wrote:

I have an old craftsman bandsaw. I installed a new blade and would like to
resaw some lumber. When I start to cut, the unit bogs down to a stop. Could
it be the motor needs replacement? If so, any suggestions on where I can get
a suitable replacement?


My Griz 14" started doing the same. It was the motor drive belt.
Tightened it up and it works dandy again.

--

Gerald Ross, Cochran, GA
To reply add the numerals "13" before the "at"
............................................
Never enough time, unless you're
serving it.




-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----