Bending 3mm metal puzzle
On 24/07/2011 10:16, john thompson wrote:
An aluminium saucepan was dropped on the kitchen floor and now the lid will
not fit on, due to a fairly small flattening of one side.
The saucepan is 16cm in diameter and the aluminium is 3 mm thick. My thumbs
are just not strong enought to push the side out enough for the lid to fit
on.
Cannot think of a way to get a good leverage on it to re-shape it, without
damaging the non stick coating on the inside of the saucepan. Grateful for
any suggestion. Thanks.
Can you make a jack that will allow you to push out the flat spot from
the inside?
Use wooden blocks with an approximately correct curve to protect the
inner non-stick surfaces.
|