In article ,
Wes wrote:

Ignoramus16406 wrote:

My 6913 lathe is missing a ball chain. Its job is to pick up oil from
the bottom of the headstock towards the spindle gears and such.

My question is what ball chain to get at McMaster-Carr as a
replacement. Thanks


I'd just contact Clausing.

I never noticed it in the drawings, you have a picture where it is located?
I might be
able to take a look at my 6903 and give you some measurements and a picture.

It's Clausing part 051-042 (ball chain belt) on my 5914. It was $13
from Clausing in 2005.

Not that it would be difficult to do using ball chain from McMaster.

Joe Gwinn