Tenma 72-905 O'scope
Todd wrote in message
...
On Jun 15, 12:28 am, "N_Cook" wrote:
Todd wrote in message
...
On Jun 14, 12:31 am, "N_Cook" wrote:
Todd wrote in message
...
Anyone have a source for a service manual for a Tenma 72-905 O'scope?
I have one that the horizontal trace stays on the left side of the
tube only. Figure it's a problem with the sweep circuit. Anyone seen
this?
Todd
With the power off check cold, initially, for differences between the 2
final X-drive transistors, usually long-tail paired.
Ok Tenma came thru with a schematic :-) Looks like I have a open 820uh
inductor that explans the low voltage on the one side. Now to try and
find one.
Thanks again for the help
Todd
+++++
You have to find why the inductor failed, maybe has a secondary function
as
a fuse.
Ok I guess I should check the current on the 2 transistors to make
sure they are close to the same then? One of the inductors has a
resistor across it for some reason, is this to prevent a oscilattion
like on my vacuum tube rf amp?
Todd
+++++
It was often a fudge/kludge to use a resistor as a former for winding the
coil on ,and nothing electrical in purpose
|