Accelerate tung oil curing?
On Tue, 03 May 2011 07:55:29 -0400, tommyboy wrote:
How can I help it along? Put piece out in direct sunlight?
Have a small fan blowing air on the piece? Something else?
If you didn't use polymerized tung oil, you're screwed. Tung is an
air-drying oil, but warmth probably helps polymerize it. Strong, hot
sunlight might cause a bubbling, though. I wouldn't try that.
Next time, try wiping on some Waterlox. I get 3 coats on the first
day, then one more coat per day afterward. 3 wiped coats provides a
minimal but complete finish.
But always remember the #2 rule in finishing: Do NOT rush it.
#1 is: Prep well and thoroughly clean before finishing.
--
Science may have found a cure for most evils; but it has found
no remedy for the worst of them all--the apathy of human beings.
-- Helen Keller
|