In article , Bob Flint
wrote:

I noticed that I must have gotten some glue on a piece of wood I'm finishing
since it doesn't take stain in the form of
a drip run...

Is there any way to fix this besides sanding it all again?

I doubt it.

Is there a way to prevent this? If I do notice some glue on a good surface,
how should I take care of it? I've been
using a wet rag... does that get it all?

Using a wet rag will smear the glue into the wood. Let it dry for a
bit, then lift it with a sharp chisel, and scrape or sand after it's
up.

djb

--
Is it time to change my sig line yet?