Thread
:
Richmond Radial Drill wiring?
View Single Post
#
2
Posted to rec.crafts.metalworking
Gunner Asch[_7_]
external usenet poster
Posts: 47
Richmond Radial Drill wiring?
On Fri, 15 Apr 2011 07:53:23 +0000,
(rshipman) wrote:
Hi,
I have a 1955 Richmond radial drill with Brookhirst switch gear etc. (I'm
based in Baldock, England, UK).
Unfortunately I can't tell you what model etc the drill is. But looking on
the internet it seems to be similar to the SR2.
Please check out images:
http://www.icknieldforge.co.uk/richmondradialdrill.jpg
http://www.icknieldforge.co.uk/richm...unctionbox.jpg
I need a wiring diagram or something for the main junction box, so I know
where to connect the incoming 3phase etc. Terminals A, B D and E seem to
be the only ones with nothing connected to them, at least on this side of
the board (can't see behind). But I really don't know where it should go.
Also can anyone tell me what the various components in this box actually
do please?
Any help gratefully received!
Junction box details:
Donovan Electrical, Birmingham B33 9BU (division of Brookhirst Igranic Ltd)
No. AIE114/727
Control Volts: 100/110
Stator Volts: 400/440
H.P.: 3 Max
Phase: 3
Hz: 50
Thanks and regards,
Ronnie Shipman
Where is the power for the 110vt control circuitry coming from?
Gunner
Whenever a Liberal utters the term "Common Sense approach"....grab your
wallet, your ass, and your guns because the sombitch is about to do
something damned nasty to all three of them.
Reply With Quote
Gunner Asch[_7_]
View Public Profile
Find all posts by Gunner Asch[_7_]