"Dennis" wrote in message
news

"mkr5000" wrote in message
...
I have a part being machined that calls for 2 captive studs to be
inserted and thought I'd try to put the studs in myself. They're
stainless, 8/32 about an inch long and require a .163 pocket
(partially drilled hole).

I thought that maybe I could build some sort of jig to keep them
straight and then tap them with a hammer?

OR--

Is there a small accessory or something that maybe I could use with an
arbor or vise? Any ideas?

Need to do them myself to save some time and money.


I fit root nuts & press in studs using a cheap air chisel/air hammer from
a discount autoshop.

I take a standard chisel and turn down the end in the lathe to suit the
fastener.

It works really well, very quick and they bind in much better than hitting
with a hammer.

I like that. I may use that for my mold alignment pins. Sometimes if I get
over zealous with the hammer I mushroom a pin and have to drive it back out.
This would totally eliminate that. I like it.