DIYbanter - View Single Post - What is the difference between scanning for channels and going directly to one?

[email protected]

On Sat, 12 Mar 2011 09:44:14 -0500, wrote:

And that pushing 1 3 on the remote would go to channel 13 whether one
had scanned for channels or not, whether digital station frequencies
had changed since the last time one scanned or not. As effectively as
if one scanned the whole spectrum, and then channeled up or down to
get to 13.

Am I right about the paragraph just above?

For some tuners if channel 13 was not put into memory during scan,
and if channel 13 does not give an adequate signal during direct entry
the channel (will take.)
Correction: should not take.