Thread
:
Dividing head
View Single Post
#
34
Posted to rec.crafts.metalworking
DoN. Nichols[_2_]
external usenet poster
Posts: 2,584
Dividing head
On 2011-03-13,
wrote:
On Sat, 12 Mar 2011 09:32:53 -0800 (PST), wolfgang
wrote:
[ ... ]
The diagram posted by DoN above illustrates the use and position of
the spacer bar/rod as discussed earlier.
If I am interpreting this right you can position a 3-jaw chuck in 60
degree intervals using this method. I do not see 90 degrees.
Use a 4-jaw chuck?
Perhaps (if the spacer is made just the right height) use on the
back ways on the other side of the same jaw? (That gives you 180
degrees from each front postion, or 60 degree steps.)
Enjoy,
DoN.
--
Remove oil spill source from e-mail
Email: | Voice (all times): (703) 938-4564
(too) near Washington D.C. |
http://www.d-and-d.com/dnichols/DoN.html
--- Black Holes are where God is dividing by zero ---
Reply With Quote
DoN. Nichols[_2_]
View Public Profile
Find all posts by DoN. Nichols[_2_]