On 3/6/2011 4:36 PM, Metspitzer wrote:
The videos on the web make it look very easy. All you need is a
steady hand. My problem is that I don't have a steady hand. (Want a
laugh? You should watch me eat with a fork)

I saw this tip on the web and considered trying it, but I can't
imagine how I would pull it off.
--------
Apply masking tape to both sides of where you want your new caulk
bead, with the edges of the tape lining up to exactly where you want
the bead of caulk to stop. This is a technique that professionals use
to ensure a perfectly even-looking bead with no mess. There should be
about an eighth of an inch between the two pieces of tape.
--
Anyone know of a guide I could use to make the tape stop? I was
thinking that a yard stick would be about the right thickness. I
could just lay the yardstick on the seam and then apply tape to the
wall/tub.

I know that a wet finger is supposed to go a long way, but last time I
tried I did not like the results. Another problem I had was to keep
the calk coming out in a smooth stream. If I were not so ashamed of
how it looked, I would post my work for a laugh. I just couldn't keep
the tip of the gun in the grove while pumping the gun.


You don't use a gun in a tub, you use a squeeze tube. Never tried the
tape, maybe next time I will. Right next to the squeeze tubes of bathtub
caulk, big box sell all sorts of tools for getting a clean bead that
work a whole lot better than an inexperienced or shaky finger. Run a
TINY bead, and use the tool to really shove it in there. And have rags
handy to wipe up the excess before it grabs, or plan on a lot of razor
work later. Maybe the tape would help with that part. A bucket of warm
water and a scrubby to keep cleaning the tool is also a good idea- it'll
gunk up fast.

Usual caveat about surface prep applies. Clean, soap-scum free,
degreased and dry is mandatory, if you want it to stick. And if you want
to make it last longer, one of those little shoe polish bottles of grout
sealer used as the last step after the caulk skims over, will keep water
from penetrating the grout and running down behind the caulk, and
causing it to let go or grow mold. Once you're done, let it dry at least
a day. In a 1-bathroom house, a proper recaulk is a major PITA, since it
takes the tub off-line for about 3 days. Day 1, heavy-duty cleaning, and
set a fan to dry it out. Day 2, do the actual work. Day 3, if no goofs
found and it seems dry, okay to use. In a 2-bathroom house, I'd double
those wait times.
--
aem sends...