Depth Gage with hook
Louis Ohland wrote:
On 2/25/2011 16:44, john wrote:
Louis Ohland wrote:
Folks, I would lie to be able to measure workpiece length while the
part is still chucked up. I see that Starrett has such a beast, but is a
bit rich. Any suggestions?
For a hollow tube a hook scale would work. If your eyes are good you
should be able to measure within a 64th or better with no problem.
How close do you want to measure it?
As close as sanity provides. Within a thou.
If you want cheap make up a hook scale without numbers and then depth
mike off the opposite end of it. Measure the length of the hook scale
and do the math. Or if you can put a straight edge across the back end
just use a depth mike.
John
|